Salamander Interactive Wall Mounts
501-518 [04.21] page 4 of 10
Mounting EZ-LIFT Mount Body to Wall
Unpack the EZ-Lift and remove the plastic cover and two foam blocks.
Locating your mount
WOOD CONSTRUCTION: locate two framing studs (minimum of
16” (405 mm) apart) at the desired location using a stud finder device.
MASONRY:
a minimum width of 16” (405 mm) is required between fasteners.
Installation of EZ1/MB16/152 Mount Body
Prepare Mounting Site
The EZ-Lift was designed to be installed on a 16” on center 2” x 4” wood stud, or
metal studs, using high-quality hollow wall anchor installed in the center of the stud
or a solid concrete wall.
WARNING: INSTALLING THE MOUNT IN UNDERRATED OR DAMAGED CONCRETE
CAN LEAD TO SERIOUS INJURY OR DAMAGE TO PRODUCT! When installing into
concrete only install the mount in a solid concrete wall made of 2500 PSI (17.3 MPa)
or stronger concrete. Never install the mount into cracked, chipped or flaking concrete.
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING
SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers
responsibility to make sure the structure to which the EZ-Lift is being installed is
capable of supporting three times the combined weight of the EZ-Lift and all
attached equipment is not to exceed the following weight capacities:
EZ1/MB16/152: 90-152lbs / 40-69kg
