EN
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before operating the
heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
1. Unpack the heater and remove all the parts from the package.
2. Place the radiator body upside-down on a scratch-free location, make sure it is stable and
will not fall.
3. Insert the front leg horizontally into the bottom of the front cover until clipped in place
fully.
4. Insert the rear leg vertically along the rear fin and press it down until fitted firmly.
OPERATING INSTRUCTIONS
1. Before using the heater make sure that it is on a flat and stable surface.Damage may occur
if it is placed on an incline or decline.
2. Set all the controls to OFF position, and insert the plug into a socket-outlet with well
grounded. Be sure plug fits tightly into outlet.
3. Rotate the thermostat clockwise to the maximum position and then switch power switch on.
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob
counter clockwise until hear a click. The thermostat can now be left at this setting. As soon as
the room temperature has dropped below the set temperature, the unit will switch itself on
automatically until the set temperature has been reached again. In this way the room
temperature remains constant with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise
to raise the temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of
the heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug from the
socket-outlet.
1
–handle
2
–thermostat knob
3
–power switch
4
–front leg
5
–radiator fins
6
–rear leg