5. Attach the conversion mount surely using the M4x14 screws.
Tighten all the screws in the sequence as shown in the above picture.
6. Attach the carburetor together with the plate tightening the cap
screw from the bottom side.
7. Attach the throttle extension
bar to the carburetor.
9. Put on the engine inserting 4
bolts in the mounting holes.
①
②
③
④
⑤
⑥
8. Beforehand fix 4pcs of M5
bolts
※
1
as stud bolts using the
pronged T nuts already placed on
backside of the firewall.
11. Attach 4 nuts※
2
to fix the engine. Flange nuts have enough
frictional surface which help prevention from loosening.
NOTE:
If the length of the 4 bolts
are not adequate, you would not
be able to attach a nut due to its
thickness.
10. Apply anti-loosening glue to
tip of the bolts before putting
nuts.
12. Finally tighten the nuts with a
spanner.
-2-
