29
|
Sailrite.com
4. Push the bobbin winder l
ever (
A
) f
orward to
move the wheel against the drive belt of the
sewing machine (
Figure 52
).
5. Disengage the Posi-Pin clutch system to
allow for bobbin winding without running the
machine. Pull the pin out of the balance wheel
and place it in the center hole, as shown, to
store
(
Figure 53
).
Note: Bobbins can also be wound while sewing.
6. Hold the thread tail and power the machine
to start winding the bobbin. Cut the tail flush
with the edge of the bobbin after about twenty
rotations
(
Figure 54
)
and then continue under
power until the bobbin is full. If adjustments
are necessary, see “Bobbin Thread Winding
Adjustment” on
page 30
.
7. To re-engage the clutch:
• Push the Posi-Pin gently into the hole in
the balance wheel.
• Rotate the balance wheel while lightly
pushing on the Posi-Pin until you feel it
connect with any of the 4 bushings holes.
• Push the Pin all the way in and release.
52
53
54
A
Summary of Contents for Fabricator
