PROG MODE
Hold down
for 2 seconds to enter the parameter setting function.
Press
until the display will show
"Prog."
Press
and insert the following parameter: program number ("P ??")
Set parameter value by pressing
to select digit and
to modify the value
Press
, the parameters will be memorized otherwise if you hold down
for 2 seconds you will exit
from the parameter setting function.
Example of execution of program number 3
"P 3"
After confirmation the oven is in Prog mode and the PID will work.
The display swaps through:
- temperature
- program information (for example P3_12 means program number 3 in execution at step number 12)
the heating led shows when the heater is on and one of the < = > led is on
NOTE: to view/modify the Prog parameters just repeat the above procedure.
Switch off
The oven can be switched off in two ways:
1) using the main switch ON/OFF. At the next switch on the oven will be again in Prog mode and the PID will work immediately.
2) using the
STOP
mode. Hold down
for 2 seconds, the display will show
"Prog"
Press
until the
display will show
"StoP"
, press
to confirm. The oven is now in stand-by, the PID is inactive and all the leds are off
COM.ON MODE
Hold down
for 2 seconds to enter the parameter setting function.
Press
until the display will show
"Com.on"
Press
, the parameters will be memorized otherwise if you hold down
for 2 seconds you will exit
from the parameter setting function.
The display shows a moving segment and all the leds are off.
After 10 minutes of inactivity the PIDLogger will change to Stop mode.
EXIT THE COM.ON FUNCTION
1) using the main switch ON/OFF. At the next switch on the oven will be in STOP mode.
2) using the
STOP
mode. Hold down
for 2 seconds, the display will show
"Stop"
.
Press
to confirm. The oven is now in stand-by, the PID is inactive and all the leds are off
Page 8
Sahara DRY,07/.2021