SageTV HD Media Extender
Page 3
Model STP-HD200
Copyright 2008 SageTV, LLC All rights reserved
For additional support, go to
or email us at
Video:
Choose one type of video output ports to connect: HDMI, Component (Pr,Pb,Y), S-
Video, or Composite.
Turn on your TV and/or home theater equipment, making sure to set those devices to use the
same audio and video connections used on the player.
Once all of those connections are made, plug in the unit’s power adapter. The unit will turn on
and, after a delay, the startup screen should be visible on your TV.
IMPORTANT! If you see no image on your TV, make sure that the TV is set to use the
same video connection used on the player. The Composite and S-Video connections should
always output a valid video signal. For other video connections: if the connections are set
correctly, use the Video Out button near the bottom of the player’s remote to change the
video output resolution used by the player. Wait a few seconds after using the Video Out
button before pressing it again to try the next video output resolution. If you still have no
output on your TV after using the Video Out button five times, see the Troubleshooting
Guide, below.
Once the HD Theater is connected, turned on, and displaying information on your TV, see the
Configuring the HD Theater
section for more setup details.
Configuring the HD Theater
During the first time setup, prompts will be displayed to configure the network, video output, and
audio output connections, described below. In addition, you will be asked whether the player
should automatically scan all folders on your local network and attached devices to find media
files or whether you will manually specify the import folders to be scanned.
Once at the Main Menu, choose from the following items for further configuration options:
Settings
The Settings menu is used to configure the HD Theater and has the following options:
Network
– Choose whether to use
DHCP (Automatic)
or
Static (Manual)
as the
method for the extender to gets its IP address on your local network. DHCP is
recommended, if your network has a DHCP server, since it will then automatically get an
address. The Static option is an advanced option: once this is selected, you will need to
manually enter your network information.
Video Output
– Choose this option to configure which video output port to use. Select
from
Composite/S-Video
,
Component
, or
HDMI
. After choosing
Component
or
HDMI
, you will then be asked to select which output resolutions will be enabled.
Tips:
1)
While on the resolution selection menu, use the Video Out button on the remote to test
the different output resolutions. After each resolution change, the screen will display the
