Sagem MY700X, User Manual, Page: 29 / 64

29
Certification and safety
information for the United
States and countries using
FCC standards
FCC Part 15 statement
This device complies with part 15, part 22 and part 24 of the
FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
WARNING
Changes or modifications made to this equipment not
expressly approved by Sagem Communication for
compliance could void the user's authority to operate the
equipment.
FCC SAR information
THIS MODEL PHONE MEETS THE FCC'S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES
Your wireless phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the limits for
exposure to radiofrequency (RF) energy set by the United
States Federal Communications Commission (FCC).
These limits are part of comprehensive guidelines and
establish permitted levels of RF energy for the general
population. The guidelines are based on standards that
were developed by independent scientific organizations
through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin
designed to assure the safety of all persons, regardless of
age and health.
The exposure standard for wireless mobile phones employs
a unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC and Health
Canada is 1.6 W/kg (*). Tests for SAR are conducted using
standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all
(*) In the United States and Canada, the SAR limit for
mobile phones used by the public is
1.6 watts/kilogram (W/kg) averaged over one gram of
tissue. The standard incorporates a substantial margin
of safety to give additional protection for the public
and to account for any variations in measurements.
252794404_my700X_US_en.book Page 29 Mercredi, 2. août 2006 4:00 16