Thank you for purchasing SAGE ShowLink and a Socket Scanner! In just a few minutes you will be setup and using the
latest technology in lead retrieval systems. Follow these instructions to set up your Socket scanner and activate your
software. You only need to program your scanner the first time you use it.
1. Powering ON: Press and hold down the small round power button
until the LED turns blue and the device beeps twice.
2. Hold the scanner about 3-4 inches from the bar code to the right and
press the trigger until the device beeps/vibrates.
800.925.7243 f. 214.631.2323 [email protected] www.sageworld.com
STEP 1 | First time scanner setup
STEP 2 | Charge your devices
1. Socket Scanner: Make sure you fully charge the scanner before the show. Leave it plugged in for at least 5 hours or until the
LED turns from RED to GREEN. Once charged, the scanner can scan thousands of leads but we highly recommend that you
take the charging cable to the show with you just in case you need it.
2. iOS: Make sure you fully charge your device that you are scanning with prior to the show and bring your power cord and
extension cord.
SAGE ShowLink Socket Scanner Setup
Scan this
if using an iOS
Device
Scan this
if using a Windows
computer
STEP 3 | Pairing your scanner to your iOS device or Windows computer
To pair the scanner with an Apple device:
1. Hold down the small power button, to power on the scanner.
2. On your iOS device tap Settings, General, Bluetooh, select iOS Socket 7xi under Devices.
Wait for the scanner to connect.
3. Once the scanner is connected, you will see the Bluetooth icon show up on your device along with the 7x1 symbol in
ShowLink.
To pair the scanner with a Windows computer:
1. Right-click on the Bluebooth icon from the notification area.
2. Select Add Device.
3. Hold down the small power button, to power on the scanner.
4. Select the Socket Scanner and click Next
5. Once the scanner is connected, you will see the Bluetooth icon show up in Windows along with the 7x1 symbol in
ShowLink.
STEP 4 | Installing the software to your iOS device or Windows computer
To install the app on an Apple device:
1. Go to the App Store on your device
2. Search for “SAGE ShowLink”
3. Click Install and then enter your Apple ID if prompted
4. SAGE ShowLink App is now installed and the icon has been placed on your device
To install the softweare on a Windows computer:
1. Visit sagemember.com
2. Enter your login credentials
3. Click the “Support” tab and then the “Downloads” button
4. Click on “SAGEShowLinkSetup.exe” and select RUN.
5. Follow th eonscreen steps to complete the operation.
6. After the install, the SAGE ShowLink icon will appear on your desktop along with in the start menu.
