page 4
CONNECTION
Route the speaker wire from the source to the speaker.
Separate about 4” of speaker wire at each conductor end.
Using a wire stripper, remove about 1/4” (6mm) of insulation from each wire.
Twist the ends of each wire to prevent fraying.
Connect the marked wire to the red speaker terminal by pressing the
release tab, inserting the wire into the hole, and then releasing the tab.
Repeat to connect the unmarked wire to the black terminal.
Connect the marked wire coming from the speaker’s red terminal to
the red (+ positive) terminal on the amplifier. Connect the unmarked wire to the
black (- negative) terminal on the amplifier.
FINE TUNE
The easy aim tweeter makes is simple and effortless to enhance your
sound experience. Tilt and rotate the tweeter in the center of the speaker
to control the sound’s direction. Over-rotating may damage the tweeter.
Adjust the Tweeter
Adjust the Sound
1)
2)
3)
4)
5)
6)
3dB response increase
3dB response decrease
default setting
+
3dB
0dB
-
3dB
+
3dB
0dB
-
3dB
+
3dB 0dB
-
3dB
Use the switch on the face of the speaker to adjust the sound of the tweeter.
There are three sound options:
+
3dB
,
0dB
, and
-
3dB
.
(note: 0dB is the default setting)
+
3dB boosts the signal and is recommended for furnished rooms.
-
3dB cuts the signal and is recommended for more open spaces.
RED
BLACK
RED
BLACK
+
R
-