64
Connecting panels horizontally
Unless stated otherwise, all dimensions are given in mm.
5.2 Using the MANTO Aligning Panel Clamp
The MANTO Aligning Panel Clamp can be used for all vertical and horizontal panel
joints. The MANTO Aligning Panel Clamp, with its aligning profile of 630 mm, provides
an absolutely tight, flush-mounted and perfectly aligned panel joint when it is used cor-
rectly.
WARNING
Risk of injury from falling MANTO panels!
If it is not attached correctly, the MANTO Aligning Panel Clamp can release and form-
work elements can fall off when being transported by crane.
Every time the MANTO Aligning Panel Clamp is attached, check that it is not resting
on the PLATINUM 100 Tie Nut. The MANTO Aligning Panel Clamp has to rest against
the MANTO panels. If necessary, attach the MANTO Aligning Panel Clamp to the next-
higher or next-lower H-rib.
Tie nut
MANTO Aligning Panel Clamp
MANTO Aligning Panel Clamp
Tie nut
630
127
100
MANTO Aligning Panel
Clamp
(code:448000)
Summary of Contents for Huennebeck MANTO G3
Page 1: ...MANTO Large frame panel formwork User guide...
Page 9: ...9 Unless stated otherwise all dimensions are given in mm MANTO...
Page 61: ...61 Unless stated otherwise all dimensions are given in mm MANTO MANTO G3 M MANTO G3 M...
Page 219: ...219 Unless stated otherwise all dimensions are given in mm MANTO...
