129
Unless stated otherwise, all dimensions are given in mm.
MANTO®
10.2 Oblique-angled corners
With the MANTO Outer Corner and the MANTO Hinged Corner it is possible to form
oblique-angled corners (as well as right-angled ones), starting with a minimum of 60°
and up to a maximum of 175°. Timber infills can be used to achieve the required wall
thickness.
MANTO panel
MANTO Outer Corner in an
obtuse-angled corner with
MANTO Aligning Panel Clamp
(code:448000)
Timber beam
MANTO Outer Corner 20 in
an acute angled corner
Hinged Corner in an
acute angled corner
See note regarding
panels with reinforce-
ment plates.
Levering
edge
No levering
edge
Hinged corner
in an obtuse-an-
gled corner
Multipurpose Waler
100
(code:450764)
Be aware that some sections are subjected to higher tensile loads (Refer to table on
The tie should normally be secured through the corner adjustment 5. At least 25 mm
of the MANTO Tie Nut must rest against the adjacent panels.
Summary of Contents for Huennebeck MANTO G3
Page 1: ...MANTO Large frame panel formwork User guide...
Page 9: ...9 Unless stated otherwise all dimensions are given in mm MANTO...
Page 61: ...61 Unless stated otherwise all dimensions are given in mm MANTO MANTO G3 M MANTO G3 M...
Page 219: ...219 Unless stated otherwise all dimensions are given in mm MANTO...
