for details
for instructions on battery installation.
Please refer to section 1.4 Uplink Payload and Data Decoding for details of decoding the receiving packet to get
the measured values.
For the Uplink Payload structure, please refer to sections B and C in
.
Figure 3. Dimensions
The Sigfox-Ready GHC flammable gas sensor is a wireless device with an integrated gas sensor to detect combustible
gas.
1.5.3.1 Preparation before installing the device at the site location:
Insert the batteries into the device in
Safe Zone
;
Step 2: Add the device to Sigfox Backend
Step 3: Install the batteries to the device
After installing the battery in 60 seconds, the first data packet will be sent to the Sigfox network. After receiving
the first data packet, the time of another packet depends on the value of the parameter:
CYCLIC_DATA_PERIOD. Additionally, you can use a Magnet Key to force the device to send data instantly.
Step 4: Decode the payload of receiving package
1.4 Uplink Payload and Data Decoding
1.5 Sensor Installation
1.5.1 Dimension drawings
1.5.2 Device calibration & configuration
If Configuration and Calibration are needed for the device, please perform those tasks in the Safe
zone, before installing the device at the site.
1.5.3 Installation