Saft WSSFCEX-GHC, Manual

Page: 7 / 8

Sensor configuration can be configured in 02 methods:
Method 1: Configuring via Downlink message. Please find the instructions in sections D and E in this link , but
please take note of the FW version of the Document.
Method 2: Configuring via offline cable .
Some parameters are read-only, and some are read and writeable.
To read the parameters, use the off-line cable as per the above instruction.
Via uplink message, users can read only one parameter, which is the CURRENT_CONFIGURATION.
The below tables are the lists of the parameters of the device.
Read-only Parameter Table
Modbus
Register
(Decimal)
Modbus
Register
(Hex)
Function
Code (Read)
No. of
Registers
Description Range Format Property Comment
2 2 3 4 FW_VERSION string Read
6 6 3 2 HW_VERSION string Read
8 8 3 2 DEVICE_ID hex Read Product ID
10 A 3 4 DEVICE_PAC hex Read Product PAC
14 E 3 1 SENSOR_TYPE 1-255 uint16 Read Sensor or
Input Type
Read/Write Parameter Table
Modbus
Register
(Decimal)
Modbus
Register
(Hex)
Function
Code
(Read)
Function
Code
(Write)
No. of
Registers
Description Range Default Format Property Comment
270 10E 3 16 4 CURRENT_CONFIGURATION hex Read/Write Check
sections D
& E in this
Payload Document
274 112 3 16 1 SERVER_CONFIG 0 uint16 Read/Write 0: Send to
Sigfox
Network
1: Send to
Dongle
276 114 3 16 1 RADIO_CONFIG 1-4 4 uint16 Read/Write RC zones
selection
1, 2 , 3, 4
is RC1,
RC2,
RC3s, RC4
277 115 3 16 1 TX_POWER 20 int16 Read/Write RF Tx
power
Note: THE SENSOR IS ONLY ACTIVE FOR OFFLINE CONFIGURATION IN THE FIRST 60 SINCE POWER UP
BY BATTERY OR PLUGGING THE CONFIGURATION CABLE.
3.2.2 What parameters of the device are configured?