3
The appliance carries a DO NOT COVER warning symbol.
This appliance is not equipped with a device to control the room temperature. Do not use this appliance in small
rooms when they are occupied by persons not capable of leaving the room on their own, unless constant
supervision is provided.
General information
Only use tap water in this appliance.
Unpack the appliance carefully and retain the packaging for possible future use, in the event of moving or
returning the fire to your supplier.
Always ensure that the appliance is sitting on a level surface.
The appliance is a flame effect only.
The appliance is designed to be built into a surround or built into a wall.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound
which is related to the operation of the flame effect. This is normal and should not be a cause for concern.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water
tank.
Moving the product without draining it, may result in t
he activation of the leak prevention valve. See ‘Changing
the Leak Prevention Valve’ paragraph below under Maintenance f
or further information.
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every 2 weeks, particularly in hard
water areas.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and dry
the sump.
The sump and the water tank in this product are treated with a biocidal product, Silver Biocide. This conforms to
the latest relevant ISO standard.
Do not drink the water from the sump or from the water tank(s).
Installation Instructions
This section describes how to install and set up your fire.
Before you start:
Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible
future use.
Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
CONNECTIONS REQUIRED IN ADVANCE OF INSTALLATION
Electrical Connection
Please ensure a 240V /13A power socket is located within 1 m of the product. The electrical connection should
be accessible during product installation so that the connection can be made to the product easily.
