MorphoWave
TM
OEM
– Installation guide
Section 3 :Installation Procedure
34
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
2015_2000009096 V4
May 2017
Preparing wall plate
Figure 9: Wall plate preparation for water tightness
Create a silicone bead all along the notch. The silicone bead shall be reduced to avoid
overflow on the upper part of the wall plate (risk to prevent product mounting).
Fixing
Be sure that a sufficient space is reserved in the wall for the passage of
cables, in particular for Ethernet.
Figure 10: Wall plate fixing
Place the wall plate against the wall, opposite the four holes pierced in the wall (see
Figure 10: Wall plate fixing).
S
ilic
on
e
IP65
S
ilic
on
e
!
