TECHNICAL NOTE
Safran Colibrys SA
30N.EVBA V2.10.16
Av. des Sciences 13 – 1400 Yverdon-les-Bains - Switzerland
T +41 58 100 5000
www.safran-colibrys.com
page 3
F +41 58 100 5001
1.3
Electrical connections
It is the user choice to mount Header connector
(Figure 1)
on J1 connecting pads or to solder the signal wires
directly on the EVBA board. The size of the soldering hole are of 0.8mm, so wires up to a conductor area of
0.5mm2 or AWG21 are suitable. The wires or the Mating connector (
Figure 2)
will ideally be hand soldered
using a PB free solder with the appropriate flux.
Note:
Connector J1 is a 14 Positions Header, Shrouded Connector 0.100" (2.54mm) Through Hole, Right Angle
This connector is delivered unsoldered to the evaluation board. The user is free to use it or to solder any
connection directly on the board.
Figure 1: Connector J1
Figure 2: Mating connector (14 pins)
1.4
Mechanical dimensions
The mechanical layout of the evaluation board is shown in Figure 3. All components are soldered on the top
and bottom surface and the board can be mounted using the 4 x Ø3.40 mm through holes:
Note: This is for the VS1002, other range looks like same
Figure 3: Mechanical Dimensions [mm] showing a VS1002
1
2
13
14
