background image

 
Copyright© 2009 

– Saflec Systems (Pty) Ltd 

www.safsys.co.za 

 

Saflec Systems (Pty) Ltd

 

SSR-202 

Wiegand Proximity Card Reader 

Revision 1.2 - (June 29, 2009) 

 
 

Quick Start Guide

 

 
Introduction 

The SSR-202 is a proximity reader that can connect using the Wiegand wiring standard. 
It can read various transponder cards at the industry standard frequency of 125 kHz, including 
Hitag

™ 1, Hitag™ 2 and HT4102. 

It includes a tri-color LED for indication of the scanner status, and a Piezo buzzer to indicate a 
successful card read. 
This unit comes with a splash-proof back cover and can be mounted in any orientation using the 
mounting screw holes. 
 
This reader has been designed to be used with the following devices: 

  SDC-510 Single door controller. 
  SDC-520 Ethernet controller. 
  SEB-720 Remote IO board. 
  Any Wiegand standard controller. 

 

 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Figure 1 

SSR-202 proximity card reader 

Summary of Contents for SSR-202

Page 1: ...ard frequency of 125 kHz including Hitag 1 Hitag 2 and HT4102 It includes a tri color LED for indication of the scanner status and a Piezo buzzer to indicate a successful card read This unit comes with a splash proof back cover and can be mounted in any orientation using the mounting screw holes This reader has been designed to be used with the following devices SDC 510 Single door controller SDC ...

Page 2: ...s will affect the number that is read from the proximity cards so the correct setting must be applied and must be standardised throughout the system to avoid problems To set 26 bit Wiegand format 24 bit data length set the rotary dipswitch on the back of the reader to A To set 34 bit Wiegand format 32 bit data length set the rotary dipswitch on the back of the reader to B Figure 6 Bit length setti...

Page 3: ...ta 0 Data 1 and Present The Present data line is not always required and can normally be ignored The indication lines Red LED Green LED and Buzzer Connect these lines ensuring that the correct cables are used Step 3 Connect the power See Fig 5 Connect the power lines to the reader making sure that correct polarity is observed Note The power supply must be a 12 Volt DC power supply capable of suppl...

Page 4: ...0 C to 70 C Storage Temperature 10 C to 80 C Enclosure Rating IP54 Digital Outputs Wiegand Specification Open collector transistor output with 4k7 Pullup Resistor to 5V DC Max Voltage on terminal 2 to 20V referenced to ground Max Load 100ma Digital Inputs Wiegand Specification TLL input with 4k7 Pullup Resistor to 5V DC Max Voltage on terminal 10 to 20V referenced to ground V Input Low 1V V Input ...

Reviews: