1. Technical Data
Gas type:
LPG Operating Pressure: 2,8 kPa
Burner type:
U shaped pipe burners and Ceramic infrared burners on
750/950/1150 and 1350 models.
Gas consumption:
250g/hour per burner.
This appliance requires a low pressure 2,8 kPa LPG Regulator to be fitted to
the gas cylinder.
Ensure that you obtain the correct regulator for the type of cylinder used with
the appliance.
Cylinders suitable for use with the appliance are as follows:
9 kg or greater, The cylinder requires a regulator with a G 5/8(5/8 BSP) left hand
thread (Bullnose fitting).
Note: Regulators must comply with the requirements of SANS 1237. If in doubt
check with your gas dealer. Gas hose must comply with then requirements of
SANS 1156-2 or BS 3212.
2. Safety Information
·
The hose and
the seal on the regulator must be checked for wear or damage
before every use and before connecting to the gas cylinder.
· Ensure the appliance is used away from flammable materials. Minimum safe
distances are: above the appliance 1,2 m at the rear and 600 mm at each side.
Table models may only be placed on a non-combustible surface.
· Do not use an appliance that is leaking, damaged or which does not operate
properly.
· Ensure that the gas cylinder is fitted or changed in a well-ventilated location,
away from any sources of ignition, such as naked flames and away from other
people.
· Keep gas cylinders away from heat and flame.
· Do not cover up or change the mixing tube air holes as this will affect the
performance of the product and may lead to an unstable flame.
· In the event of a burnback, where the flame burns back and ignites at the jet,
immediately turn off the gas supply by firstly closing the control valve on the gas
cylinder and then the appliance burner valve. Wait 1 to 2 minutes and light the
affected burner in the normal manner. If the burnback reoccurs call a service
technician to examine the appliance and do not use it until it has been certified
as safe to do so.
· If there is a leak on your appliance (smell of gas), turn off the gas supply, firstly
at the gas cylinder and then on your appliance by turning the respective knobs
or levers to the off position. Disconnect the cylinder from the appliance and take
both units outside to an area away from any sources of ignition. Connect the
cylinder to the appliance, open the cylinder valve and with the appliance valves
in the closed position, check for a gas leak as indicated below.
Drop in Gas Braai
Gas Supply line by specialist
to Right hand side of unit.
Use 3/4 female fitting
to connect gas to appliance.
14
14
Cutout Size A
254
Cutout Size 250
14
A
14
14
14
254
Cutout Size 250
535
Cutout Size 505
Model
2B
3B
4B
5B
A
750
950
1150
1350
Front View
Side View