NOTES
7
8
5.0 Operating Instructions
Your grill has now been unpacked and assembled. It is now time to plug your grill into a
115 Volts Single Phase 20 amp outlet.
WARNING
Plug this unit into a properly grounded 115 Volt - Single Phase - 20 AMPS outlet.
Grill TNG Control
(Touch ‘N’ Grill)
Follow the instructions on the Digital Control Grilling System panel of your grill and other
suggestions in this section to operate your Safire
Model 4400-EC-224/115 Grill.
Your digital control grill illustration (Figure 4a), consists of one (1) Digital Control Grilling
System Panel.
Preheat grill 10 - 12 minutes at desired temperature control setting before grilling.
General notes for above
1. Always check grease tray for excess grease or food particles before each
use. If required, remove excess grease or food.
2. It is recommended that all grilling, cooking or baking be accomplished with
the grill hood in the closed position.
3. At the completion of any grilling, cooking or baking, do the following:
A. Clean cooking grid with soft wire brush of any excess greas and
food particles.
4. The Cooking Tips on the right side of the Digital Control Grilling System panel
are suggested cooking times.
5. DO NOT allow any corrosive or harsh chemical cleansers to get on the Digital
Control Grilling System panel.
1. Read owners manual fully before operating this grill
2. Plug into 115 Volts @ 20 amp outlet
3. Press ON button to power on grill
4. The grill will default to a temperature of 350° and a time of 60 minutes.
5. Press the up arrow (
▲)
to increase temperature or the down arrow (
▼)
to
decrease temperature
6. The grill will automatically power off in 60 minutes. If more grilling time is
required, press the ON button before it times out. The grill will reset to 60
minutes and maintain your set temperature.
7. When you are done grilling, press the off button and the grill will shut down.
OPERATING INSTRUCTIONS
350F
Digital Control Grilling System Panel
4a
