To set clock
SET CLOCK
– Press
SET CLOCK
at any time to set hour and minutes, then press
“NEXT”
to exit. The clock is a 24
hour clock, so AM or PM must be set accordingly. (May make adjustment when “hour” or “minutes” blink.)
Valve programming
(Follow these guidelines for water softeners & combo systems.)
Step Action
Selections
Next Action
1
Press NEXT
“Softening” will appear. For softeners simply . . .
Press NEXT
2
Brining direction (keep down flow as the default)
Press NEXT
3
Refill. (“POST” is the default). Post is preferred.
Press NEXT
4
1
st
backwash (See chart on page 2)
Press NEXT
5
Brine draw (See chart on page 2)
Press NEXT
6
2
nd
backwash (See chart on page 2)
Press NEXT
7
Downward rinse (See chart on page 2)
Press NEXT
8
Salt refill (See chart on page 2)
Press NEXT
9
Capacity (See chart on page 2)
Press NEXT
10
For the next fields press NEXT until the clock appears
Press NEXT
1
Press NEXT
Hardness. (Set hardness and add 4 grains for every 1 PPM of Iron.)
Press NEXT
2
Days over ride. (Default is 14 days.) Adjust or . . .
Press NEXT
3
Regen time. 2 AM is default. Adjust hour and minutes or . . .
Press NEXT
Note clock is a 24 hour clock. Make sure AM and PM are correct.
Add water to brine tank
Prior to initial startup and regen, add 6” of water to brine tank from sanitary source.
Do not add salt to the brine tank at this time. This is the last procedure!
Start-Up
With the valve’s inlet and outlet closed, initiate a manual regeneration and follow these directions.
1.
Press REGEN button and hold button for 3-5 seconds for immediate regen.
2.
Let the valve advance to BACKWASH.
3.
Open valve’s inlet slowly 1/3 to fill mineral tank.
4.
Allow air to escape (listen until spurting stops).
5.
When water flows from drain, open inlet valve fully.
6.
Make sure drain line is not restricted.
(Note: Do not “tee” drain line with a filter.)
7.
Continue backwash until water runs clear.
8.
Press and release REGEN to advance to BRINE RINSE.
9.
Notice if water level in the brine tank is going down.
(This is important.)
10.
Press and release REGEN to advance to the 2
nd
backwash.
11.
Press and release REGEN to advance to RINSE.
Finally . . .
1.
Open the valve’s outlet to supply water to the house.
2.
Go in the house and open a faucet. See if water runs clear.
3.
Go back in the house and shut off faucet.
Add salt
It’s now time to add salt. Initially, this is typically three to four bags of salt. Do not over fill. (Crystal salt is recommended.)
Salt volume should be monitored routinely for proper results.
Customer orientation
It is important to provide customers with an initial orientation. This should include how to reset the clock, the importance
of checking salt levels routinely and how the resin cleaning process works.
Warranty
Signature Series Safety Zone Water Systems come with a limited warranty. Five years for valves, and ten years for tanks.
Resin, activated carbon and filter media come with a quality guarantee only. See warranty card or go to