For more help and resources, call 1-800-544-1108 or visit www.safety1st.com
11
10
Belt Clip
(down)
Carry Loop
(up)
Using Your Monitor
Using Your Monitor
VIDEO ON/OFF BUTTON
Video ON/Off Button is on the top of Parent Unit. Press the Video On/Off
Button to shut-off the video screen. The Video Off icon will appear. Press again
to bring back full video.
POWER INDICATOR
The power indicator is a green LED that indicates
that the unit is on and functioning.
LINK INDICATOR - OUT OF RANGE
If the unit is working and goes out of range, the no-link
icon will appear and the link indicator LED will illuminate
red. If product is detected as close to losing link, where
signal quality is losing over 50% of it's information,
monitor will keep giving image, but link indicator LED
will flash red indicating that loss of link is possible.
Additional Parent Unit - Audio Only (Receiver):
VOLUME CONTROL BUTTON
Volume can be easily adjusted to any desired listening level by pressing the
Volume Control Button, so you can be sure to hear your baby at all times.
Volume Control Button is on the top right side of Parent Unit. To adjust
volume, press up (+) or down (-). The sounds are transmitted through the
wide range speaker. It is essential to check reception regularly. Refer to
Use and Care section.
SOUND LIGHTS (5 LEDs)
As baby’s voice gets louder, the sound lights will illuminate from 1 light up to
5 lights. Low sound is one LED illuminated and rises incrementally as baby’s
noise level increases until all 5 LEDs are illuminated.
POWER INDICATOR
The power indicator is a green LED that indicates that the unit is on and
functioning. If LED turns red, this is a low battery indication.
LINK INDICATOR - OUT OF RANGE
If the unit is working and goes out of range, the link indicator red LED
will illuminate.
BELT CLIP & CARRY LOOP
The Belt Clip is convenient for
portability. You can clip the
Parent Unit to your belt
or waistband. The Belt Clip
also easily converts to
a carry loop.
Additional Parent Unit - Audio Only (Receiver):
BATTERY CHARGING
IMPORTANT:
Parent Unit will not operate unless rechargeable battery
pack is installed first. To maximize battery life, charge a new rechargeable
battery pack in Parent Unit for 12+ hours before first use. You may operate
Parent Unit with an AC adapter while charging batteries.
LOW BATTERY
With power on and unit operating on battery power, a green LED will be lit.
When the LED turns to red, it indicates that the battery is dying. You need to
plug in the Audio Parent Unit within 5 to 10 minutes after red battery LED
appears or battery power will fail.
WHAT TO EXPECT FROM BATTERY LIFE
A Fully charged battery being used with both video and audio typically lasts approximately
6 hours. During the last 5 minutes, the large flashing red battery will start flashing. You need
to plug in the Parent Unit within 5 to 10 minutes after red battery starts to flash or battery
power will fail.
Rechargeable batteries are prone to what is referred to as the "memory effect". What this
means is that if a battery is repeatedly only partially discharged before recharging, the
battery "forgets" that it has the capacity to further discharge all the way down. To illustrate:
If on a regular basis you fully charge your battery and then use only 50% of its capacity
before the next recharge, eventually the battery will become unaware of its extra 50%
capacity which has remained unused. The battery will remain functional, but only at
50% of its original capacity.
The way to avoid the "memory effect" is to fully cycle (fully charge and then
fully discharge) the battery at least once every two to three months. Simply leaving the
device in the ON position and letting it run can discharge batteries completely. This will help
insure your battery remains healthy. Once discharged, recharge the battery completely
according to the manufacturer's instructions.
Baby Unit (Transmitter):
PROPER POSITIONING
IMPORTANT:
When choosing locations to set up the Baby Unit and Parent Unit,
follow these guidelines:
• For best sound quality, place Baby Unit 3 feet (0.9 m) away from the baby.
• Adjust volume dial on Parent Unit to appropriate level to minimize feedback.
• During use of the monitor, sound quality deteriorates as you reach the limits of
the monitor's range. If this happens, you will need to move the Parent Unit in
closer proximity to the Baby Unit.