For more help and resources, call 1-800-544-1108 or visit www.safety1st.com
11
10
Using Your Monitor
Using Your Monitor
SPLIT SCREEN
Split screen can be used when there is more than one Camera
paired to the Parent Unit. Press the Center Menu button then
scroll over to the split screen icon and press the center menu
again to select.
BELT CLIP & FOOTREST
The Belt Clip is convenient for portability. You can clip the Parent Unit to your
belt or waistband. The Belt Clip also easily converts to a footrest.
CAMERA LENS FOCUS
To improve the picture quality, manually turn the lens on the camera to the left
(counter clockwise) until picture is clear.
Adding Additional Cameras:
Note: This product can accept up to 4 cameras. To order an additional camera
(#08903), please contact our Customer Service Department by phone at
1-800-544-1108 or visit www.safety1st.com
• Plug the AC adapter into AC jack in the bottom of the Camera and the other
end into a standard wall outlet.
PAIRING BUTTON:
Please bring the Camera and Parent Unit close to each other during the
process, to make sure the RF signal is strong enough and to prevent failure
caused by interference.
Ensure Camera and Parent Unit are both on. Press and HOLD the center main
menu button on the parent unit, then press the pairing button on the back of the
Camera. The camera is now paired. To check if additional camera is connected
follow the steps indicated in the split screen section above. If camera is not
paired simply repeat the paring instructions again.
LOW BATTERY
With power on and unit operating on battery power, a green LED will be lit.
When the LED turns to red, it indicates that the battery is dying. You need to
plug in the Audio Parent Unit within 5 to 10 minutes after red battery LED
appears or battery power will fail.
WHAT TO EXPECT FROM BATTERY LIFE
A Fully charged battery being used with both video and audio typically lasts
approximately 6 hours. During the last 5 minutes, the large flashing red battery
will start flashing. You need to plug in the Parent Unit within 5 to 10 minutes
after red battery starts to flash or battery power will fail.
Rechargeable batteries are prone to what is referred to as the "memory effect".
What this means is that if a battery is repeatedly only partially discharged before
recharging, the battery "forgets" that it has the capacity to further discharge all
the way down. To illustrate: If on a regular basis you fully charge your battery and
then use only 50% of its capacity before the next recharge, eventually the battery
will become unaware of its extra 50% capacity which has remained unused.
The battery will remain functional, but only at 50% of its original capacity.
The way to avoid the "memory effect" is to fully cycle (fully charge and then fully
discharge) the battery at least once every two to three months. Simply leaving the
device in the ON position and letting it run can discharge batteries completely.
This will help insure your battery remains healthy. Once discharged, recharge the
battery completely according to the manufacturer's instructions.
Baby Unit (Transmitter):
PROPER POSITIONING
IMPORTANT:
When choosing locations to set up the Baby Unit and Parent Unit,
follow these guidelines:
• For best sound quality, place Baby Unit 3 feet (0.9 m) away from the baby.
• Adjust volume dial on Parent Unit to appropriate level to minimize feedback.
• During use of the monitor, sound quality deteriorates as you reach the limits of
the monitor's range. If this happens, you will need to move the Parent Unit in
closer proximity to the Baby Unit.