Note:
Review your vehicle’s owner manual for vehicle belt use.
E-4
Install Rear-Facing with
Vehicle Belts
Secure LATCH Belts
You
MUST
fasten the LATCH
connectors to the side of
base as shown when using
the vehicle seat belts.
NOTE:
You may need to raise
the headrest to thread the
LATCH belt.
2.
Store Top Anchorage
Hook (Tether)
Attach the top anchorage
hook (tether) to the base as
shown. Tighten tether to
remove the slack.
1.
Secure your child in the
child restraint. Recheck
the recline angle to
make sure it is reclined
according to your child’s
weight. Repeat steps if not
reclined correctly.
E. Installing Rear-Facing
52
continued on next page.
Check Belt Tightness
Grasp the child restraint at
the belt path with one hand.
Push and pull the child
restraint from side to side,
forward and back. The child
restraint should not move
more than 1 inch.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Secure LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Attach the top anchorage hook (tether) to recline
stand when used rear-facing.
Failure to follow these warnings can result in
serious injury or death.
