If the car is fitted with a child restraint anchorage point.
Locate the anchorage point behind the rear seating position (consult the car
owner’s handbook for the location of the anchorage point).
Remove the thread plug from the parcel shelf / floor / roof and install the
attachment bolt as shown in Fig 7.
CAUTION DO NOT
OVER TIGHTEN
THE ATTACHMENT BOLT.
MAXIMUM TORQUE
20 Nm (Newton Metre).
If the car is not fitted with a child restraint anchorage point.
For sedans only
- Drill a 9mm diameter hole in the parcel shelf on the centre
- line of the seating position as shown in Fig 8 Install the anchor bolt as shown in Fig 9.
For vehicles other than sedans
- In Australia, consult your nearest child restraint fitting
station or traffic authority for vehicle inspection to find the best, correct position for the
placement of the anchorage point, and for the correct attachment bolt length and use
of spacers. In New Zealand, consult the agent for the vehicle.
WARNING: CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN DRILLING THE
9MM HOLE DO NOT DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST BE PROTECTED FROM
SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DIRECTED ABOVE. IT MUST
NOT BE HOOKED ONTO ANY OTHER OBJECT.
FRONT OF VEHICLE
Fig 8
Spacers
(if required)
Reinforcing
Washer
Anchor Fitting
Front of vehicle
Centre line of seating position
7
FRONT OF VEHICLE
Fig 7
Attachment Bolt
Fig 9
FRONT OF VEHICLE
Vehicle Trim
Lock Washer
Securing Nut
Vehicle
Metal Structure
Attachment Bolt
Summary of Contents for CCA 2010 A
Page 22: ...21 NOTE...
Page 23: ...22 NOTE...
