Safemate BTC-1005A Manual Download Page 2

11. Before charging, check the battery type and max. Charging current is allowed, or 
get this information from battery supplier. 
12. Use goggle during connect or disconnect battery charger to battery. 
13. Do not operate this product in explosive atmospheres, such as in the presence of 
flammable liquids, gases or dust, could result in serious injury. 
14. 

Don’t insert any metal things into the ventilator of battery charger. 

To reduce risk of damaging the Battery, avoid dropping any metal tools onto the 
battery. 
15. 

Don’t put the battery charger too close to the battery during charging. 

16. During charging, the battery must be placed in a well ventilated area 
17. This appliance can be used by children aged from 8 years and above and persons 
with reduced physical, sensory or mental capabilities, or lack of experience and 
knowledge if they have been given supervision or instruction concerning use of the 
appliance in a safe way and understand the hazards involved.children shall not play 
with the appliance.cleaning and user maintenance shall not be made by children 
without supervision. 
18. If the supply cord is damaged, it must be replaced by the manufacturer, its service 
agent or similarly qualified persons in order to avoid a hazard.   
19.It only can be used for lead-acid rechargeable batteries. 
 

 

 

- warning against recharging non-rechargeable batteries

 

- The battery terminal not connected to the chassis has to be connected 
first. The other connection is to be made to the chassis, remote from the 
battery and fuel line. The battery charger is then to be connected to the 
supply mains;

 

- After charging, disconnect the battery charger from the supply mains. 
Then remove the chassis connection and then the battery connection.

 

- cleaning and user maintenance shall not be made by children without 
supervision

 

 
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this 
manual before set up or use of this product. 
 

Control Board and Display 

Function Buttons and LED Display 

 

 
Switch of voltage Selection 

Press switch up for charging 6V battery and press switch down for charging 12V battery. Charge 
voltage can not be selected after charging or during charging

 

Summary of Contents for BTC-1005A






Reviews: