background image

Note: 

When 

motion is detected & 

the 

battery 

is

 weak

, 2 seconds 

after the alert tone plays, the unit will emit a "Beep Beep" every 5 

seconds, repeating 5 times.  This is notice that the battery should 

be changed.

Do not mount the 

speaker 

to the wall or door frame until you

have successfully 

setup and tested the device

.

Volume control: 4 levels

 & set to highest volume level at

 the

factory.

Each unit is programmed to the "ding-dong" sound from the

factory. User may change this melody.

If you are happy with the preset volume & tone, you can skip

the  step titled "Setting the Tone and Setting Volume Level"

section of this manual.

When battery is low

 a special tone is emitted.  See "Note" in

battery installation section of manual

 below

.

The unit resets every 5 seconds after each activation.

ERA-PIR

-

SPK

Owner’s Manual

Introduction
The 

ERA-

PIR

-SPK

 

is 

a passive infrared (PIR) sensor

 with an internal 

speaker that is 

activat

ed when a combination of heat & 

movement is detected in the monitored zone. 

When the 

sensor

 

is activated

, the internal speaker will play

 one 

(1) 

of 

three

 (

3

)

 

different 

tones

.

  

The unit was designed so you can mount the 

bracket on the door frame or wall and easily pivot the lens to 
optimize the desired monitored zone.

 

Helpful Tips:

1.

Remove the screw located on the

backside of the case using a phillips

head screwdriver (see figure 1).  Once

the screw is removed, open the case.

2.

Remove top half of case from

 

lower

 

half

of the case  to find

 

the battery

 

holder

(see figure 2)

.

3.

Install a fresh 9-volt alkaline

 

battery

.

4.

Follow the instructions for

"Setting the Tone and Volume

 

Level"

prior to reassembly.

ERA-PIR-SP

K

 Battery Installation:

The sensor is powered by a 9V alkaline battery.  Follow the steps below to 
remove the cover and install the battery.  

Note: 

Program the tone and 

volume level prior to reassembling the unit.

figure 1.

figure 2.

Setting the Tone and Setting Volume Level

Setting the Tone:

By  default,  each  zone  is  programmed  by  the  factory  to  play the 

ding-dong  sound

  at  the  highest  volume  level.

    You  can skip this 

step if you are 

OK

 with 

this tone and volume level

.

1.

Hold down the "

v

olume control and tone selector

" button 

for

approximately 

3 seconds

 

until the 

RED

 LED on the

 

board is

lighted 

(see figure 2)

.  

The solid red light lets you know the unit 

is in 

program mode

.  

When the LED is red, release the

 

button.

2.

Press the "

v

olume control and tone selector

" button to scroll

through the 

3

 available 

tones, stopping at the one you like.

3.

Hold down 

the "

Volume control and tone selector

" button

until the red LED goes off.  No red

 LED means the unit IS NOT

in programming mode.

Note: 

Unit will exit programming mode automatically after 5

seconds with no activity.

Reviews: