A. The power cord is short to avoid entanglement or tripping.
B. An extension cord can be added if used properly.
C. If an extension cord is used:
1. Its power capacity must be at least the same as that of the device's power consumption.
2. The extension cord must not hang over the edge of the device. Ensure that children cannot pull it,
and that the risk of tripping is low.
Take the device out of the packaging. Remove all packaging from the unit and accessories.
Power cord advice:
3
32. Keep hands and utensils out of the container while blending to reduce the risk of severe injury to
persons or damage to the blender. A rubber scraper or spatula may be used, but only when the
container is removed from the motor base and the blades are not moving.
33. Do not operate with loose or damaged blades. Do not remove the blade assembly from the container.
Contact your authorized Safecourt service representative for service or replacement.
34. When making nut butters or oil-based foods, do not process for more than one minute after the
mixture starts to circulate in the container. Processing for longer periods can cause damage to the
container and motor overheating.
35. In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must
not be supplied through an external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility
Danger to children!
Danger to life from suffocation/swallowing packaging material. Keep the packaging material away
from children. Dispose of it immediately.
Remove the packaging material and all components. Caution: There are sharp blades in the blender
jug. Before using the blender for the first time, wash the containers, removable lids, and blade
attachments with warm, soapy water and dry them carefully. Do not immerse electrical parts in water!
Precautions for safe use of the mixer
Never use the device without the lid. Do not leave your blender unattended when operating. Any repair
and servicing, or the replacement of parts must be performed by KeMar or an authorized service
representative.