The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
bead of silicone caulk into the inside bend of the “A” panel corners.) Position both sets of assembled
panels on the marked concrete base (Fig 2).
3.
Inspect the alignment of the “C” (access) panels during the assembly process. Verify that their
removal and replacement allows adequate space and positioning within the openings and with the
adjacent panels prior to attaching any bracket to the concrete.
4.
Set the “C” access panels in place with about a 3/16” gap on each side of the panels.
A.
Set the “D” (roof) panel on the “B-A-B” assemblies.
5.
Using one (1) hex headed screw for each, attach the Outside Corner Anchoring Brackets to the
“B-A-B” sections. Using one (1) anchor for each bracket, fasten them to the concrete (Fig 1A). Fasten
one (1) Outside Corner Anchoring Bracket at both corners on one side.
A.
Attach the Inside Anchoring Brackets to the “B” panels at the bottom, inside at the concrete (Fig 1B).
Using one (1) anchor for each, fasten each bracket to the concrete. Fasten the Inside Side Anchoring
Brackets to the “B” panels and concrete along one side of the enclosure.
B.
Insert the Inside Roof Clips into the “D” (roof) panel at the “B” panel studs (Fig 1C). Using one (1) hex
headed screw for each, attach the clips to the “B” panels as shown.
C.
Repeat Steps 5, 5A and 5B on the other side of the enclosure.
NOTE: model sizes and configurations vary, see the chart.
6.
Provide a ground-fault interrupter device in all electrical circuits per all applicable codes. Install the
