Safe Fleet PRIME DESIGN VRR-TC11B, Assembly Instructions Manual, Page: 5 / 12

PRIME DESIGN, A SAFE FLEET BRAND ▪ Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118
▪
Phone: 651-552-8554
▪
Toll Free: 1.8.PRIME.RACK
▪
Fax: 651-552-1799
▪
Email: info@primedesign.net
▪
Website: www.primedesign.net
TM & © 2018 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6764268, 6971563, 2364879, 8857689, 8511525, 8991889, 2271515, 2364897, 9506292, 9481313, 9481314, 9796340, 6202807, 6427889, 9415726 AND OTHER PATENTS PENDING
5
Rear
Front
Lef
t
Right
VRR-TC11B
ASSEMBL
Y INSTR
UCTIONS–FBM MOUNTINGS
1.6
Reinstall the Mounting Bracket Nut hardware as shown,
but do not tighten.
Install the front Mounting Brackets as shown and slide
into position over the Bracket Nut.
1.5
Loosen bolts
1.4 1.3
Foam pad
Mounting Plate
Install three sets of Channel Hardware per channel
as shown below.
Install the fasteners through the innermost factory roof
holes as shown then torque the nuts to 60 in-lbs.
Do not install or fasten Hardware to the outer front
and rear roof holes until Step 1.9.