Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
6
1
4
2
3
View From Vehicle Front
L Post Position
Z Post Position
Fig. B
Installer’s Note:
This rack is labeled for L and Z Post
installation. These will be installed with the Rotation
open. Begin by removing the Ratcheting Handle from
the vehicle’s cargo hold, placing it on Drive Shaft’s
end, then opening the Right Hand Rotation.
Do not extend the Slide. It must remain
closed for correct Slide Z Post installation.
SLIDE L POST
1.1
The Rotation Assemblies have a factory attached L and Z
Post positioning label. Refer to this label for initial Slide L
Post assembly position.
1.2
Place the Slide L Post into the bottom groove of the Rear Slide
Assembly, ensuring the L Post seats into the Slide’s outer
bottom groove as seen in Figure B below.
INSTALLATION SEQUENCE
SEE QUICK START GUIDE FOR ADJUSTMENTS
VRR-GM31G-ST BO
X
ASSEMBL
Y INSTR
UCTIONS–L POSTS & Z POSTS
Summary of Contents for PRIME DESIGN VRR-GM31G-ST
Page 11: ...Page Intentionally Left Blank ...
