Safe Fleet Prime Design PCR-0005, Quick Start Manual

Page: 13 / 16

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
13
M8 Locknut
Flat Washer
M8 x 35MM
Carriage Bolt
View from vehicle front
PCR-0005
ASSEMBL
Y INSTR
UCTIONS–LEFT SIDE CLAMP DO
WN
NOTE: The orientation of
the bolt hole faces away
from the Crossbar
Place the Front Hook Clamp Bracket removed in Step 14.1
into the lower groove of the Crossbar, and slide it on top of
the Front Ladder Hook Clamp
14.3 14.4
Reassemble the Front Clamp Down Tube Holder
using the fastening hardware removed at Step
14.1. Do not tighten until Step 14.6
14.6
Torque to 90 in-lbs
14.5
Adjust the Front Hook until it aligns with the Rear Hook. Perfect
alignment may not be possible in all instances, and depends
upon the location of the Crossbar Mounting Brackets. If such
interference should occur, align the Hook as close as possible.