Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
21
Lef
t
Right
Rear
Front
Channel Rear
Channel Front
(B) 48.00” ErgoRack
59.25” AluRack
(B) 48.00” ErgoRack
39.50” AluRack
(A) 96.00” ErgoRack
98.75” AluRack
Flush
Rear
Front
Lef
t
Right
M8 X 20MM
Lock Washer
Flat Washer
Rear
Front
Lef
t
Right
Fig. A
Fig. B
Flush
Push to stop
Fig. B
Fig. A
Apply silicone sealant
(not provided) to screws
Mid Crossbar
Strip Nut
FBM-1017
ASSEMBL
Y INSTR
UCTIONS–HR L
WBEL U
N
IV
ER
SA
L
FB
M
2.6
Loosen nuts
3 Crossbar models: Position
the rear and center Mounting
Brackets as shown.
Attach Mounting Brackets to the Aluminum
Strip Nuts located in the Channels
2.5
2.7
Set to distances shown below:
Use Dimensions A for 2 Crossbar models.
Use Dimensions B for 3 Crossbar models.
Do not torque the Crossbar Mounting Brackets until Step 3.4.
Finger-tighten them into designated dimension to hold them in
place, then proceed to your Feature (FEA) Assembly Manual.
2.3
2.4
Torque all M8 x 25MM Flat Head Screws to
150 in-lbs. Apply Silicone Sealant to screw
heads to seal against water intrusion.
2.2
The Channels include
aluminum Strip Nuts for a
3 Crossbar configuration.
For 2 Crossbar configurations,
disregard the extra Strip Nut.
Position the Rear
Channel to full stop
as shown in Figure A.
Torque nut to 90 in-lb.
Position the Front
Channel until flush to
End Caps as shown in
Figure B.
Torque all remaining
nuts to 90 in-lb.
*2 & 3 Crossbar models:
Position the front Mounting
Brackets as shown.
*2 Crossbar ErgoRack models:
See Page 24 regarding center
Crossbar Mounts.
