Fold Her
e
1.
Determine a mounting location for the camera.
Cameras must be installed with the cabling running through the post, and inside the wall panels.
2.
Determine which 4 of the 6 available screw holes will be used to fasten the mounting post to the vehicle.
Use the base as a drilling template to lay out the drilling pattern.
3. Drill the four screw (1/8”) holes in the panel.
4. Drill the cable (3/4”) hole in the panel.
Remove any sharp edges to avoid damage to cable.
5.
Thread the camera cable from the panel hole through the post.
6.
Using the 4 screws provided, fasten the mounting post to the vehicle panel.
7.
Pull the camera cable through the mounting post and connect to the recorder.
8. Feed the cables back into the panel while fitting the camera base to the mounting post.
9.
Using the screws provided, attach the camera base to the mounting post.
10.
For further camera alignment and operation details, refer to the installation guide provided with the
camera.
Installation Procedure
Installation Diagrams
Camera base (CQ
model shown; dome
and cable not shown)
Attach to the vehicle
using the supplied
mounting screws
(600-0038)
Mounting post
(sample shown - ac-
tual post appearance
may differ based on
kit being installed)
