Fold Her
e
Warning: Blocking the Ambient Light Sensor
Take caution when positioning the lens, ensuring that the ambient light sensor is always unobstructed
when the camera is fully assembled. An obstructed sensor will prevent the camera from working properly.
3. Loosen the adjusting screw to adjust the pan, tilt,
and rotation angle, then re-tighten the screw.
4.
Finally, re-install the cover using the cover screws.
5
4
1
3
2
7
6
8
9
Mounting the Camera
1. Use the supplied template to mark out the
mounting area. Drill the screw holes on the
surface.
2.
Loosen the cover screws to remove the cover
from the camera and fix the mounting base to the
surface with the appropriate screws.
Camera Components
1.
Cover
2. Bubble
3. IR
4. Base
5. Lens
6.
BNC cable
7. Camera Sealing Gasket
8. Ethernet RJ45 cable
9. Reset button
Important: Positioning the Lens
The ambient light sensor must be pointed downwards (or at the “6:00” position) when positioning the lens.
If the sensor is facing up (or at the “12:00” position), then the image will be upside-down.
Important: Camera Sealing
Keep the camera sealing gasket clear of any
debris and or cables prior to installing the lid to
ensure a reliable seal. Also, care should be made
to not damage the gasket during installation.
