Unfold the D Back Panel and lay it out flat INSIDE
between the two Side Panels and toward the Top
Shelf. Line up the holes in the Back Panel with the
holes in the steel Side Panels. Insert a E Plastic
Push Fastener through the TOP hole on each side
of the Back Panel, into the holes in the Side Panels
(if necessary, tap the fastener heads gently with a
small hammer or mallet until seated). Fasten the
TOP hole of each side ONLY!
2
7121-37: 2 of 4; Rev. 7; 07/02
FLAP FROM CARTON
CORNER
CONNECTOR
SIDE PANEL
TOP SHELF
ASSEMBLY
Gently slide the connector prongs of the top shelf
assembly into the TOP ends of the C Side Panels
until they snap into place.
Hint:
Tear off a carton flap, and use it as a guide to help the
corner connector slide past the edge of the steel, as shown.
Once the edge of the connector slides inside the steel,
remove the flap and finish pushing the connector into place.
TOP:
SQUARE HOLES
BOTTOM:
ROUND
HOLES
3
TWO HOLES
NO FASTENER
D
Q
Q
Q
Q
Q
Safco Products Company, New Hope, MN 55428
Q
Q
Q
Q
Q
Insert a A Corner Connector into each end of the
B Top Shelf. Carefully line up the prongs on the
connector with the openings on the shelf ends, and
gently push in until the connector snaps into place.
Q
Q
Q
Q
Q
SNAPS
Q
Q
Q
Q
Q
A
Q
Q
Q
Q
Q
B
Q
Q
Q
Q
Q
A
1
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
E
Q
Q
Q
Q
Q
C
Q
Q
Q
Q
Q
Place the F Bottom Shelf (Thick) into position at the
bottom of the unit (the back has the hole in the center
of the long edge), line up all corner holes, and fasten
with G Sheet Metal Screws (two per corner).
4
Q
Q
Q
Q
Q
G
Q
Q
Q
Q
Q
F
TWO SCREWS
PER CORNER
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
