11
10
STEP14
: Use Wedge (HW10), Screw M 3.5 x15.5 (HW11)
to �ghten the back of media stand by using screwdriver.
J
STEP13
: Hold the frame door with posi�on of the upper pin shown in
facing upward. Put the frame door by inser�ng it to the upper groove
on Top Board (1), then place the lower part aligned into the groove
on bo�om board (2).
Repeat this step for the other door. Slide the doors to right and le� ensuring
the doors has been placed properly in the provided track.
TIPPING RESTRAINTS KIT INSTALLATION GUIDANCE
AA1 x 2
AA2 x 4
AA3 x 4
AA4 x 4
AA1
AA4
1
Different wall materials require unique wall fasteners.
The wall plugs (AA2) and screws (AA3) are designed for fixing to concrete walls only.
Please consult your local hardware store to ensure you are using the correct hardware for your wall type.
2
3
4
AA2
AA1
AA3
AA1
1. Attach bracket (AA1) securely to the back top of the furniture using screw (AA4) provided. Allow 8 - 10 cm from each side.
2. Please make a hole for
wall plugs
position on the wall and minimum 15 mm below bracket secured to the back of unit attach the wall
plugs (AA2).
3. Locate the other bracket (AA1) on the wall over
wall plugs
(AA2). Place furniture into position so both brackets (AA1) are vertically in the
line.
4. Lace the end of the restraints strap through the larger hole in each brackret. Ensure the restraints strap with grids surface facing the inner
loops. Bring both ends together and slide the flat end through the locking end and draw it through until all slack is removed.
5. Make sure that the strap is securely laced & locked.
Installation Instructions :
8-10cm
8-10cm
4
5
Grids Surface
