WHAT YOU HAVE TO DO IN ORDER TO START YOUR
MINARELLI AUTOMIX
ENGINE
FOR
THE
FIRST
TIME
Pour some oil-gas mixture at
3%
Into the fuel tank In order to effect
the first lubrication of the engine. Then:
1) Replenish the oll tank with SAE
20
not synthetic oll for
2
stroke
cycle engines.
2)
Remove the pumpcover cap located on the right side of the
engine by unscrewing No. 8 (see Fig. No. 1 ).
3)
Unscrew the air drain screw completely (It Is located on the
pump, see No.
4
Fig.
1)
In order to let the air move out.
4)
Set the vehicle on the central stand and start the engine but keep
It at low revolutions. In this position the rear wheel Is allowed to
rotate freely.
5)
From the oll tank, the oll passes through a filter (No.
6,
Fig.
No. 1) located between tank and pump. When you see It spilling
out from the drain hole (No.
4,
Fig. No.
l)
and with no air
bubbles In It, close the hole by Its screw. Immediately after you'll
see the low and continuous refilling of the tube (No.
7,
Fig. No.
1) connected to the carburator connector.
6)
Only when the tube (No.
7,
Fig. No.
1)
Is completely filled up,
you can replenish the fuel tank with gasoline only.
'R
Make sure tl'latih& grommets (No.
5
Fig. No.
1)
set on the ends
of the oil tubes are located In thelc right position, then replace
pump cover cap on the right side of the engine (see No.
8, Fig. No.1).
8) The filter (No.
6,
Fig. No. 1) must be checked and cleaned up
by some gasoline about every 1800 miles. After this control,
should the filter turn out to be not correct, replace It by a new
one.
15