SAF SBS 2220 H0, Repair Instructions

Page: 31 / 42

5 Replacement procedure
31
en
XL-SA30000RM-en-DE Rev A • 02.2016 • Errors and changes excluded © SAF-HOLLAND
Fig. 58 - Removing the carrier
4. Remove the carrier from the brake calliper by gen-
tly rocking the carrier to release it from the guide
pins and bellows. Once released, press the guide
pins back enough to be able to lift out the carrier,
see ► Fig. 58 .
Caution!
Where indicated, use an SAF special tool only.
D
C
Fig. 59 - Removing the guide pins
5. By hand, push out the fixed bearing (C) and float -
ing bearing (D), see ► Fig. 59 .
E
Fig. 60 - Removing the bellows and guide pins
6. Remove both guide pin bellows (E), see ► Fig.
60 . If necessary, use a small screwdriver in order
to lever them out. Be careful not to damage the
guide pin bellows sealing surfaces if using a tool to
lever out the bellows!
H
F
G
F
Fig. 61 - Removing the slide bearings and side composite bushing
7. Carefully follow the steps below, ► step 8 and ►
step 9, to remove the two leading bearings (F) and
the spacer (G) as well as the trailing composite
bushing (H), see ► Fig. 61 .