7
XL-DB20020UM-en-US Rev A · 2019-06-05 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Mounting and Operating Instructions
Figure 1
FOUR (4) GRADE
8 BOLTS
FOUR (4)
WASHERS
FOUR (4) GRADE
C LOCK NUTS
7. Mounting Instructions
1. Use a mounting structure of sufficient
strength to support the rated capacity
of the pintle hook in accordance with
SAE J849 and SAE J847.
2. Use the hole pattern described in
Section 2.
3. Insert and tighten all four (4) new 3/4"
diameter Grade 8 bolts, ASTM Grade C
lock nuts and hardened 3/4" washers.
The recommended minimum torque is
300 ft.-lbs. when using a nut and bolt
and 350 ft.-lbs. when using bolts only
(Figure 1)
.
8. Operating Instructions
1. Before operating, inspect for wear,
damage, missing parts, and secure
mounting. Correct as required before use.
2. Position the drawbar eye over the
horn of the pintle and lower into place
(Figure 2 and 3)
.
3. Engage the drawbar with the
coupling device per the manufacturer's
instructions.
Failure to correctly secure
the drawbar can result in
separation of the pintle
hook and drawbar, which,
if not avoided, could result
in death or serious injury.
Figure 2
Figure 3
