Saeco Xsmall Plus, Service Manual, Page: 33 / 42

Page 4 / 9 Rev. 00 / Jul. 2008 Saeco Int.
07 DISASSEMBLY XSMALL
7.5. Gear motor
Gear motor
1 ) Loosen the screws holding the boiler pin
in place, remove it and loosen the other
screws shown.
2 ) The following are located inside the
compartment protected by the casing:
- Electric motor (A) with gears (B) and
(C) for transmission and timing of the
brewing unit.
- Dreg drawer present microswitch (D).
- Brewing unit present microswitch (E).
- Microswitch (F) intercepting the brewing
unit home and dispensing phases.
- Remove the gear (C) that meshes with
the motor transmission shaft.
- Remove the large gear (B).
- Remove the motor (A), complete with
transmission shaft.
3 ) Replace the gear (B), making sure that
the imprint of the arrow is aligned with the
opening containing the pin (P).
4 ) When replacing the motor and the
transmission shaft, make sure the guide
runners (L) are in the right position.
Grease the shaft thoroughly and evenly.
5
1
3
2
A
B
B
D
E
F
C
P
H
L