14
English
1
•
2
•
3
•
4
•
Fig.15
☞
Fig.13
Fig.14
6
3
4
•
2
1
3
4
2
1
•
•
•
•
•
•
4.12 Assembling Saeco Card system
- Connect the antenna cable ref.
1
(Fig.
13
) to the clamp on the universal
module ref.
2
(Fig.
13
).
NOTE:
Take care when performing this procedure. Make sure
that the metal chip ref.
3
(Fig.
13
) is underneath the
strain relief ref.
4
(Fig.
13
) and that the screw head
and washer ref.
5
(Fig.
13
) make contact with the
center conductor ref.
6
(Fig.
13
).
- Install the universal module ref.
2
(Fig.
14
) inside the front door ref.
1
(Fig.
14
) using the supplied screws.
- Place the antenna ref.
3
(Fig.
14
) in one of the three positions on the front
door ref.
1
(Fig.
14
). Use double-sided adhesive to firmly secure the an-
tenna in place.
- Apply the adhesive guard ref.
4
(Fig.
14
), supplied with the kit, over the
antenna. Make sure the antenna is completely covered and protected.
- On the front door exterior ref.
1
(Fig.
15
), apply the adhesive label ref.
2
(Fig.
15
) in correspondence with the antenna ref.
3
(Fig.
15
) on the inte-
rior. The label indicates where to hold the Card to communicate with the
Saeco Card system.
- Using the supplied flat cable, connect the universal module ref.
2
(Fig.
14
) to the 20-pin connector ref.
4
(Fig.
15
) on the electronic board.
5
