TROUBLESHOOTING
103
BREW UNIT MISS.
BREW UNIT BLOCK.
DREGDRAWER MISS.
GRINDER BLOCKED
Trouble
No message is displayed
The automatic coffee brewing
does not start
The automatic coffee brewing
does not start
Water is dispensed instead of
coffee
Steam and hot water are not
dispensed
Coffee is dispensed too quickly
Coffee is dispensed too slowly
Coffee is not hot enough
Coffee is not creamy enough
The machine coffee brewing is
reduced, it takes longer to heat
and the dispensing is not
sufficient
The central unit cannot be
removed
Possible causes
The machine is not getting power
The service door is open
Pre-ground coffee selection button
has been pressed, but the relevant
container is empty
The steam/hot water spout hole
is clogged
Grinding too coarse
Grinding too fine
The central unit filter is clogged
The cup has not been preheated
The coffee blend is not suitable
or is not fresh. Grinding is not
correct (too fine or too coarse)
Descaling the machine
The central unit has not been
correctly positioned
Solution
Turn the main switch on, check
plug and fuse
Close the service door is
Properly fit and lock the central
unit
Clean the central unit (see page
84)
Fill with water or coffee beans
and restart the cycle
Fit the coffee grounds container
properly
Service the coffee grinder (see
page 85)
Fill one measuring spoon of
pre-ground coffee
Clear the hole with the aid of a
thin needle
Adjust the grinder on a finer
grinding, e.g. from 5 to 3
Adjust the grinder on a coarser
grinding, e.g. from 5 to 7
Clean the filter
Heat the cup on the heating
plate
Try another coffee blend
Descale the machine, as
described at page 85
Switch the machine on, close
the service door, fit the coffee
grounds container and wait until
the machine resets.
WATERTANK EMPTY
COF. BEANS EMPTY
84
IMPORTANT SAFEGUARDS
When using your coffee maker, basic safety
precautions should always be followed, in-
cluding the followed to reduce the risk of
fire, electric shock, and/or injury to persons
including the following:
1
●
Read all instructions.
2
●
Do not touch hot surfaces. Use
handles or knobs.
3
●
To protect against electric shock, do
not place cord, plug or appliance in water
or other liquid.
4
●
Close supervision is necessary when
any appliance is used by or near children.
5
●
Unplug from the outlet when not in
use and before cleaning. Allow to cool
before putting on or taking off parts, and
before cleaning the appliance.
6
●
Do not operate any appliance with
a damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any manner. Return appliance
to an authorised service facility for
examination, repair or adjustment.
7
●
The use of an accessory not
evaulated for use with this appliance may
cause injuries.
8
●
Do not use outdoors.
9
●
Do not let cord hang over edge or
table or counter, or touch hot surfaces.
10
●
Do not place on or near a hot gas
or electric burner, or in a heated oven.
11
●
Always attach plug to appliance first,
then plug cord into the wall outlet. To
disconnect, turn any control to the off
position, then remove plug from wall outlet.
12
●
Use this appliance only for its
intended use as described in this manual.
13
●
Keep the cord away from heated
surfaces.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUTORIZED SERVICE PERSONNEL ONLY
WARNING
RISK OF FIRE OR ELECTRIC SHOCK
DO NOT OPEN
