50
Help Message Displayed
How to Reset the Message
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO BREWING POSITION
ESC
A beverage with milk has been selected. The machine requires the carafe handle
spout to be placed into dispensing position .
Press the button "ESC" to cancel the selection.
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO RINSING POSITION
ESC
The carafe rinse function has been selected .
Press the button "ESC" to cancel the selection.
PLACE MILK CARAFE
IN ITS HOUSING
ESC
The selected operation requires the milk container for brewing. Insert the
container in the machine as specifi ed in the manual.
Press the button "ESC" to cancel the selection.
17/05/09
04:17 pm
USER
MENU
BENERAGE
MENU
SETTINGS
MENU
SELECTED
USER
Perform a descaling cycle on the machine .
When this message is displayed, it is still possible to use the machine, but its
correct operation might be compromised .
Damages caused by failure to descale the machine are not covered by warranty.
17/05/09
04:17 pm
USER
MENU
BEVERAGE
MENU
SETTINGS
MENU
SELECTED
USER
The machine requests the "Intenza" water fi lter to be replaced with a new one.
Replace the fi lter as described on page 7.
The alarm is displayed only if the "Filter Enable" function is set to "ON".
(See page 36) .
17/05/09
04:17 pm
USER
MENU
BEVERAGE
MENU
SETTINGS
MENU
SELECTED
USER
The sensor for the Fingerprint Enable procedure is not working properly.
Clean it thoroughly .
If even after an thorough cleaning the failure is not solved, contact the service
centre .
17/05/09
04:17 pm
USER
MENU
BEVERAGE
MENU
SETTINGS
MENU
SELECTED
USER
Flashing red light . Machine in Stand-by .
The Stand-by settings can be changed .
Press the "
" button.
RESTART TO SOLVE
THE PROBLEM
(E xx)
An event has occurred which requires the machine restart. Take note of the code
(E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If the
problem persists, contact the service centre .
maCHine WarninGS
