Saeco Intelia Deluxe HD8906, Manual

Page: 22 / 286

CALC
CLEAN
- The display shows the following icon to indicate that the rinsing cycle is
finished.
14
Rinse the water tank and fill it with fresh water up to the MAX level. Slide
the water tank back into the machine.
15 Press the OK button to end the descaling cycle.
16 Place a container under the coffee and milk dispensing spouts.
17
The display shows the following icon to indicate that the machine is
heating up.
- The machine performs an automatic rinsing cycle.
18
Remove and clean the milk carafe see chapter ‘Cleaning and
maintenance’, section ‘Weekly cleaning of the milk carafe’. Insert the
water dispensing spout into the machine.
19
Remove and empty the drip tray. Slide the drip tray back into the
machine.
20
Remove and rinse the brew group see chapter ‘Cleaning and
maintenance’, section ‘Clean the brew group’.
The machine is now ready for use.
Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end
without turning off the machine. In case you get stuck during the cycle or in
case of power failure or accidental disconnection of the power cord, you
can exit by pressing the standby button. If this occurs, empty and rinse
carefully the water tank, then fill it up to the CALC CLEAN level. Follow the
instructions in chapter ‘First installation’, section ‘Manual rinsing cycle’
before brewing any beverage. If the cycle was not completed, the machine
will require another descaling cycle to be performed at your earliest
convenience.
Warning icons and error codes
Warning signals are displayed in red. Below you find a list of the
warnings that may appear on the display and their meaning.
- Fill the water tank with fresh water to the MAX level indication.
22
English