Saeco Incanto Classic, Service Manual

Page: 68 / 224

5. SERVICE PROGRAMME INCANTO S-CLASS
Page 16/18 REV.1 FEB.2005 Saeco International Group
Function/Standard Setting range Increment Comments
----HEATING----
SENSOR ADJUST 96
To adjust processor tolerances.
If the temperature in test mode
with a set measuring resistance of
3246
Ω exceeds or falls short of
the specified temperature value
(96
° C) by more than 1 ° C, the
value indicated in test mode must
be applied to adjust the sensor.
No measuring resistance: Do not
change!
NORMAL TEMP.
° C 88 70- 130°C +/- 1 Normal temperature is used if not
more than 6 min. have elapsed
since last coffee dispensed.
HIGH TEMP.
° C 109 70- 130°C +/- 1 If no coffee is dispensed for an
extended time (over 6 min.), the
next coffee will be heated to a
higher temperature to compensate
for cooling of the brewing unit
and the associated temperature
loss.
TEMP. 1st COFFEE
° C 117 70- 130°C +/- 1 Used when dispensing the first
coffee after the machine has been
turned on, to compensate for the
high temperature loss due to the
cold brewing unit and water pipes.
TEMP. INCREASE
° C 0 0-50°C +/-1 The boiler temperature is
increased by a set value shortly
before brewing in order to pre-
heat the boiler. and compensate
for the temperature drop during
the first water flow.
GRINDS COUNTER
Number 0-50 +/-1 Counts number of coffee cycles.
When this value reaches the
Grinds Stop value, "GRINDS
CONTAINER EMPTY" will be
displayed. (Reset by removing
dregs drawer for emptying - min.
6 sec.)
GRINDS STOP
12 5-50 +/-1 Number of cycles until "EMPTY
GRINDS CONTAINER" is
displayed.
1 EXPRESSO
(ml) Number Counts number of times expresso
is dispensed
Not resettable
1 COFFEE
(ml) Number Counts number of times coffee is
dispensed
Not resettable
1EXPRESSO LUNGO
(ml) Number Counts number of times expresso
lungo is dispensed
Not resettable