ENGLISH
• 11 •
ENGLISH
note: the machine is ready when the brew button
light (16) is permanently on.
note: If it is not possible to dispense a
cappuccino as described, prime the circuit as
explained in section 4.5 and then repeat the steps.
the same process can be used to heat other
beverages.
• After this operation, clean the steam wand with a wet
cloth.
9 CleAnInG
Maintenance and cleaning operations may only be
carried out when the machine has cooled down and has
been disconnected from the power supply.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and filling it up
with fresh water daily.
•
(Fig.21-22)
- Every day, after heating the milk, remove
the external part of the Pannarello and wash it with fresh
drinking water.
•
(Fig.23)
- The steam wand should be cleaned every week.
In order to do this operation, you have to:
- remove the external part of the Pannarello (for standard
cleaning);
- loosen the ring nut (without removing it);
- remove the upper part of the Pannarello from the steam
wand;
- wash the upper part of the Pannarello with fresh drinking
water;
- wash the steam wand with a wet cloth and remove any
milk residue;
- replace the upper part of the steam wand (make sure
it is completely inserted);
- tighten the ring nut.
Reassemble the external part of the Pannarello.
•
(Fig.24)
- Empty and clean the drip tray every day.
• Use a soft cloth damp cloth to clean the appliance.
•
(Fig.17)
- To clean the portafilter proceed as follows:
- remove the filter, wash it thoroughly with hot water.
- remove the adapter (if fitted), wash it thoroughly with
hot water.
- wash the internal part of the portafilter.
• Do not dry the machine and/or its components using a
microwave and/or conventional oven.
Once descaling has been performed (see section 10), the
brew unit filter and the gasket should be cleaned.
To clean the filter, proceed as follows:
• Loosen the screw fixing the filter to the brew unit by means
of the screwdriver which is supplied with the scraper.
• Remove the filter and wash it thoroughly with a neutral
detergent.
• Rinse and reinstall the filter; fasten the screw by means
of the screwdriver which is supplied with the scraper.
To clean the gasket, proceed as follows:
• insert the scraper into the brew unit as shown;
Summary of Contents for 10003137
Page 6: ...ENGLISH Fig 13 Fig 14 Fig 15 Fig 16 Fig 17 Fig 18 Fig 19 Fig 20 Fig 21 Fig 22 Fig 23 Fig 24...
Page 18: ...FRAN AIS Fig 13 Fig 14 Fig 15 Fig 16 Fig 17 Fig 18 Fig 19 Fig 20 Fig 21 Fig 22 Fig 23 Fig 24...
Page 30: ...ESPA OL Fig 13 Fig 14 Fig 15 Fig 16 Fig 17 Fig 18 Fig 19 Fig 20 Fig 21 Fig 22 Fig 23 Fig 24...
Page 43: ......
