27
ERROR CODES
GUIDE MESSAGE THAT APPEARS
HOW TO REMOVE THE MESSAGE
out of service (xx)
restart to fix…
Where (xx) identifi es an error code.Turn off and after 30
seconds turn the machine on again to restore normal
operation.If the problem persists, call Saeco or an
authorized service centre and give the code (xx) shown on
the display.
close coffee bean lid
Close the coffee bean lid to be able to make a beverage.
fill container wth coffee
Put coffee beans into the bean hopper.
insert the brew group
Insert the Brew Group in its place (see page 26).
insert grounds drawer
Insert the coffee grounds drawer.
empty grounds
This preliminary warning does not stop the machine from
functioning. Proceed until the next message appears.
empty grounds drawer
Remove the grounds drawer and dispose of the used coffee
grounds (see page 25, steps 1 and 2.).
Note: The grounds drawer must be emptied only when
the machine requires it and when the machine is turned
on. If you empty the drawer with the machine turned off
it will not reset the count of cycles.
close door
In order for the machine to operate, the side service door
must be closed.
fill the water tank.
The tank must be removed and refi lled with fresh drinking
water.
empty the drip tray
Open the side service door and empty the drip tray located
under the Brew Group.
WARNING: WHENEVER THIS MESSAGE APPEARS, BE
SURE TO EMPTY THE COFFEE GROUNDS DRAWER AS
WELL.
change filter
The water fi lter must be replaced in the following cases:
1. 60 litres of water have been dispensed;
2. 60 days have passed since its installation;
3. 20 days have passed after the machine’s last use.
Note: this message only appears when the fi lter alarm
function has been set to “on” (see page 19, menu 2.4).
carafe missing
milk island missing
The steam knob has been turned to the
position and
either the Milk Island has not been installed or the carafe is
not positioned correctly. Install the Milk Island or position
the carafe correctly.
Otherwise, turn the knob until it is in the rest position ( ).
descale
A descaling cycle must be performed on the machine’s
internal circuits (see page 22).
stand-by…
energy saving…
Press the
button.