Keep the machine in a dry place, far from the
reach of children.
Should the machine not be used for a long
period, keep it from dust and dirty.
Maintenance
Periodically check the machine and clean it in
accordance to the instructions.
Disposal
Machines which are no longer operational
should immediately be made non serviceable,
by cutting the power cord. Machines should be
delivered to a public disposal centre.
Troubleshooting
In case of failure, fault or suspected damage
following a fall, unplug the machine immedi-
ately.
To fix problems, follow the instruc-
tions in the table below. Otherwise
contact authorised personnel.
50
49
Possible cause/causes
The machine is not getting power
The service door is open
The steam key is being pressed
The pre-ground coffee selection key
has been pressed while there is no
coffee in the container
The steam/hot water spout hole is
clogged
Grinding too coarse
Grinding too fine
The central unit filter is jammed
The cup has not been preheated
The coffee blend is not suitable,
coffee has not been recently
ground, the pre-ground coffee has
been ground too thin or too coarse
Limescale in the machine
The central unit is out of position
Trouble
No message on the
display
The automatic coffee
brewing does not start
Water is dispensed
instead of coffee
Steam and/or hot water
are not dispensed
Coffee flows too quickly
Coffee is flows too slowly
Coffee is not hot enough
Coffee is not creamy
The coffee brewing is re-
duced, the machine takes
longer to heat and the water
capacity is not correct
The central unit cannot be
removed
Only skilled personnel are authorised to service and repair the machine. The user might incur serious injuries should repairs
not be properly carried out. The manufacturer declines any liability whatsoever, should repairs fail to be carried out
according to the instructions contained in this manual. Furthermore, in these cases warranty rights cannot be honored.
BREW UNIT BLOCK.
BREW UNIT MISS
WATERTANK EMPTY
COF.BEANS EMPTY
READY FOR USE
OVERTEMPERATURE
DREGDRAW. MISS.
GRINDER BLOCKED
Resolution
Turn the main switch on, check plug
and fuse
Close the service door
Insert and lock the central unit
Clean the central unit (see page 46)
Disactivate the steam function and
drain the machine (see page 44)
Fill with water or coffee beans and
restart the cycle
Drain thoroughly the machine again
Fit the coffee grounds container
properly
Clean the grinder
Fill with pre-ground coffee
Clear it with the aid of a thin needle
Adjust the grinder to a finer grinding,
ex. from 6 to 3
Adjust the grinder to a coarser grind-
ing. ex. from 6 to 7
Clean the filter
Place the cup on the heating plate
Try another coffee blend
Carry out the machine descaling, as
described at page 47.
Switch on the machine. Close the
service door and fit the coffee grounds
container. The machine returns auto-
matically in its starting position.
TROUBLESHOOTING
DISPOSAL
Man. Titan 0313.959 ING (UL)
12-12-2000, 16:09
10
