Digital Wireless Microphone Systems
Transmitters:
3
2
1
4
8
7
9
11
10
12
(Figure 1)
(Figure 2)
Recharge the batteries by inserting the
cassette into the SACOM
™
Charging Dock.
Sacom-Quick-Start-Guide-130610.indd
SABINE INC.
l
13301 NW US Highway 441
l
Alachua, Florida 32615-8544 USA
l
Phone: +USA (386) 418-2000
l
Fax: +USA (386) 418-2001
l
www.SacomUSA.com
PODIUM GOOSENECK:
The SACOM
™
Podium microphone combines the professional audio specs and security of a wired
mic with wireless convenience. For use with battery power or permanently install the microphone
using USB power.
When the Gooseneck Mic is in use, the LED signals:
RED = Audio Mute
GREEN = Audio Passes
BLINKING RED = Battery Low
BLINKING GREEN = Sync Successful
SACOM
1.
™
Capsules:
Select cardioid or super-cardioid sensitivity polar patterns.
Goosenecks:
2.
Two flexible sections to extend over a laptop or briefcase. Available in 12, 18
inch lengths.
Radio-transparent ABS Top:
3.
Stylish design that hides and protects the antenna.
Cast Metal Bottom:
4.
Zinc base bottom adds stability and absorbs desk noise.
Power LED:
5.
(see fig. 2 below)
Button Programming Options:
6.
p
press to talk
p
press to mute
p
toggle on or off
Power Switch Programming Options:
7.
p
On / Off
p
On / Mute
p
On / On.
USB Port:
8.
Doubles as the USB recharger connection and computer programming port. The
transmitter operates normally under USB power, with dead or no batteries for permanent
installations. When charging using the USB Port, The LED signals: RED = Charging / OFF =
finished charging.
I/R Sensor:
9.
Inputs programming instructions and encryption key from the receiver.
Battery Cassette:
10.
Push tab to remove the battery cassette. Recharge the batteries by
inserting the cassette into the SACOM
™
Charging Dock. (See figure 1) The battery cassette
holds four, off-the-shelf, AA, NiMH batteries for up to 9.5 hours continuous usage per charge.
Keyholes:
11.
For permanent mounting
Rubber Feet:
12.
Absorb desk noise and provide a stable, non-skid base.
5
6
RF Exposure Information for DS80T, DS80H, DS80C and DS80P Wireless Transmitters
l
For the DS80H Handheld transmitter:
When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from your mouth and keep the antenna at least 2 inches (5 cm) away from your
head and body
l
For the DS80T BodyPack transmitter:
To maintain compliance with the Body Worn configuration use only supplied accessories. Other body-worn accessories or configurations may NOT comply with the FCC RF
exposure requirements and should be not be used.
l
For the DS80P Podium transmitter:
Keep the podium base at least 20 cm from your body.
l
For the DS80C Conference Table-top transmitter:
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating
in conjunction with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures. End-users and installers must be provided with antenna
installation and transmitter operating conditions for satisfying RF exposure compliance.
l
The information listed above provides the user with the information needed to make him or her aware of RF exposure, and what to do to assure that this radio operates with the
FCC RF exposure limits of this radio.
l
This wireless microphone also complies with the following guidelines and standards regarding RF energy and electromagnetic energy levels as well as evaluation of those levels for
human exposure:
FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
American National Standards Institute (C95.1-1992), IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
American National Standards Institute (C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially Hazardous Electromagnetic Fields — RF and Microwave.
Certified under FCC part 15.247 / Certified by IC in Canada under RSS-210
FCC: RBODS80P, RBODS80T, RBODS80H, RBODS80C / IC: 8240A-DS80P, 8240A-DS80T, 8240A-DS80H, 8240A-DS80C
