© 2022
Step 1 of 4
Order #XXXXX
Locked layer contains
placeholder marks.
When Assembled
Steps:
1) Attach base plates [1] lower verticals [2A] and [3A], using bolts.
2) Connect verticals [2A to 2B] and [3A to 3B], using connection bars [B].
See
Straight Connection with Knobs
detail.
3) Connect horizontals [4A to 4B] and [5A to 5B], using connection bars [A].
See
Straight Connection with Knobs
detail.
4) Connect assemblies [2A/2B] and [3A/3B] with assemblies [4A/4B] and [5A/5B].
See
Corner Connection with Knob
detail.
5) Attach graphic to
Velcro
on back of assembled Backwall.
Item
1
2A,2B
3A,3B
4A,4B
5A,5B
Description
Base Plate
42” S40 Vertical Extrusion w/ A10 Clamps
42” S40 Vertical Extrusion w/ A10 Clamps
45” Z45 Horizontal Extrusion
45” Z45 Horizontal Extrusion
Qty.
2
1,1
1,1
1,1
1,1
Canopy
Mount
Connector
Set Screw
S40
Attach connector to top of vertical
extrusion then tighten set screws
to secure.
Insert canopy mount into threaded
hole in top of connector then turn
canopy mount clockwise to tighten
in place.
Canopy Mount Attachment
Turn to
tighten
Connection bars [
B
]
stay attached to [
2A,3A
].
Slide connection bar between
extrusions, then turn knobs
clockwise to tighten lock.
Straight Connection
with Knobs
Do not over tighten Knobs
Knob
Knob
Corner Connection
with Knob
Turn knob clockwise
to tighten lock.
Do not over tighten Knobs
Knob
Keep Canopy Mounts
attached to [
2B,3B
].
Keep A10 clamps
attached to [
2A,2B,3A,3B
].
Canopy
Mount
Canopy
Mount
Connection Bar
1
Bolt
Bolt
1
3B
2B
B
B
4B
4A
5B
5A
A
A
Velcro
on extrusions
must face to
BACK
of
assembled Backwall.
2A
3A
Velcro
on
BACK/Bottom Edges
of Top Horizontals
Velcro
on BACK/Top
Edges of Bottom
Horizontals
Velcro
on BACK/Inside
Edges of Right Verticals
Velcro
on BACK/Inside
Edges of Left Verticals
Horizontal Placement
Stopper
Set upper horizontal extrusion
on top of stopper of verticals.
FRONT VIEW
Connection bars [
A
]
stay attached to [
4A,5A
].
Backwall Assembly
